Your shopping cart is empty!
 

Projects

House Mouse Good Luck Card

Materials

House Mouse Decoupage CD Rom

Pink Card
White Card
Stick on pearls

Foam pads
Double sided tape
Pinflair Glue gel
 

 

Step One

Print out the three pages of the decoupage shown, plus one sheet of the matching backing paper.

 

Step Two

Cut white card 42cm x 16.5cm. If you don’t have a large piece of card, use an A4 sheet and cut another to measure around 16.5cm. Fold over 4cm of your original A4 piece and stick this piece under it, making the size required. Fold two 16.7 lengths and one 8cm length as per the photo.

 

Step Three

Cut backing paper 15.5cm square, being careful not to use the “spoon” edges. Mount this onto pink card with double sided tape, leaving a small border. Add this to the middle section of your card as shown.

 

Step Four

Add the “spoon” edges of your backing paper to either side of your mounted panel as shown and place your single layer decoupaged image at an angle using foam pads. Add your sentiment mounted onto a scrap of pink card and three little pearls.

 

Step Five

Cut out the card on page one of the decoupage sheets and add it to the bottom 9cm of your card using double sided tape. Add your decoupage to this. A tip is to add the glue gel to the picture rather than the piece you are layering as you need to make sure there is no gel at the top which pokes above the fold. Finish with three little pearls on the bottom left.

 
Top 50 Crafters